Permeable Paving Aggregate to BS EN 13242:2002. Widely Used for installation below permeable paving blocks to ensure the structural load of the paving system is carried and the correct drainage requirements are obtained.
Aggregates were first quarried by local authorities from the deposit located at Laragan, Elphin, Co. Roscommon in the early 1940’s. Today the quarry has grown to be the supplier of choice to all local authorities of the surrounding region.
The deposit is a particularly clean homogenous limestone and is particularly suited for the production and manufacture of road making materials comprising the full spectrum and grades of aggregates.
The crushing plant is one of the most modern in the industry and comprises a unique set of secondary and tertiary processes that produce very consistent clean road making materials.
Ready for addition of cement. Blend of Lough Neagh sand and 14mm aggregate ready for addition of cement by customer to produce homemade concrete.
For general building needs. High quality Lough Neagh building sand for general building needs.
High specification road making material. 28mm to dust. Used for hard standings and pavement construction.
High specification road making material. 38mm to dust. Used for highway construction and road reinstatement after laying of services.
A single sized 6mm stone.
Used exclusively for bedding of water mains, sewer and storm water drains.
A 10mm single sized stone. High quality single sized stone for mixing of concrete and bedding of pipes.
A 14mm single sized stone. Ideal for finished surface on yards, avenues and paths. Maximum material thickness 25mm.
19mm single sized clean stone. A single sized clean stone for use as a concrete aggregate, drainage stone or pipe surround.
38mm single sized clean stone. A single sized clean stone for use in field drains, soak aways and pipe surrounds (on concrete pipes).
50mm single sized clean stone. A single sized clean stone for use in field drains and soak aways.
3mm down material. Used for bedding pipes and cables. Can also be used below flagstones. Surfacing of pedestrian paths. The maximum material thickness 25mm.
A 19mm stone graded to dust. Making up levels on existing or new hardcore to a maximum thickness of 50mm. Can be used as temporary or final surface on top of crusher run for yards, paths, roads and lanes.
A 38mm stone graded to dust. Typical uses – making up levels on existing ground or on new hardcore to a maximum thickness of 75mm, finishing surface on yards, site roads and farm lanes.
63mm stone graded to dust. Typical uses – road and yard construction. Can be used to a minimum depth of 70mm ideal for resurfacing existing yards, making up levels beneath sub floors and topping off on coarse filling.
Single sized 100mm stones. Ideal for construction of access roads and hard standings, where drainage is a requirement in the construction of the road.
100mm graded to dust Premium grade product for construction of roads, carparks and hard standings where depths in excess of 150mm are required.
A low cost material to be used where depths in excess of 150mm are required. Typical applications would be access roads into building sites, floor filling into houses, farm roads – ideal where conditions are dry underfoot.
Selected clean stone for use in gabion cages in retaining wall construction and hand placing in river revetments and embankments.